This article explains how to set up the envelope section of Logic Pro's AutoFilter. To add movement to the filter type chosen in the filter section, it uses the ADSR envelope, a basic element of synthesizers. By adjusting how strongly the envelope applies with the Cutoff_Mod fader and controlling when the envelope triggers with the threshold value, you can fine-tune the sound. Combining these parameters enables a wide range of expression, from flashy, wobbling sounds to sounds with only subtle movement.
Adjusting the filter's movement in Logic AutoFilter
The "filter type" chosen in the previous "filter section":
what adds movement to it is the "envelope section".
Using "ADSR", which always appears in synthesizers and soft synths,
we will adjust the filter effect.
AutoFilter video index
1_Filter section
2_Envelope section *This video
3_LFO / distortion section
Video point: Setting Cutoff_Mod
"ADSR" is something we explain often on this blog, but
how much of this "ADSR" should be reflected in the sound?
That is what "Cutoff_Mod" determines.
When the fader is at "0", the "ADSR" has no effect at all,
so raise the fader to some extent and adjust.
A good approach is to set up the "ADSR" first and then fine-tune.
For details on "ADSR", see the following article.
Video point: Setting the threshold
The "threshold" monitors the track's volume.
The "ADSR" above is triggered when the volume exceeds the reference level.
This determines "what the reference level is".
The lower you set the "threshold value",
the more easily the "envelope" is triggered, so the sound changes more dramatically.
By adjusting these,
you optimize the sound for the song, whether a "wobbling sound"
or a "sound with just a little movement".
Frequently Asked Questions
Q1. What is the envelope section of Logic Pro's AutoFilter used for?
It adds changes over time to the filter type chosen in the filter section. Using the ADSR envelope, you can dynamically control the filter's movement and give the sound expression.
Q2. What happens if Cutoff_Mod is set to 0?
The ADSR envelope has no effect at all, and the filter stays static. Because the sound gets no movement, it is usually recommended to raise the fader somewhat and adjust.
Q3. What changes when I lower the threshold value?
The lower the threshold value, the more easily the envelope is triggered and the more dramatically the sound changes. Because the track's volume exceeds the reference level more often, the filter effect is triggered more frequently.
Q4. How can I learn more about ADSR envelopes?
Check the related article "AMP_Envelope" referenced in this article to learn detailed envelope settings, including volume control.
















